Rear View Monitor System (w/o Wide View Front Monitor System)

PARK ASSIST / MONITORING: REAR VIEW MONITOR SYSTEM (w/o Wide View Front Monitor System): HOW TO PROCEED WITH TROUBLESHOOTING

HINT
* Use the following procedure to troubleshoot the rear view monitor system.
* *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP

NEXT -- Continue to next step.

2. CUSTOMER PROBLEM ANALYSIS

NEXT -- Continue to next step.

3. INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage with the power switch off.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

NEXT -- Continue to next step.

4. PROBLEM SYMPTOM CONFIRMATION

Result:





B -- Go to step 6
A -- Continue to next step.

5. SYMPTOM SIMULATION

NEXT -- Continue to next step.

6. CHECK FOR DTC (NAVIGATION SYSTEM)*

(a) Refer to DTC Check/Clear of Navigation System Reading and Clearing Diagnostic Trouble Codes.

Result:





B -- Go to NAVIGATION SYSTEM How to Proceed With Troubleshooting
A -- Continue to next step.

7. CHECK IF THE SAME SYMPTOM APPEARS IN THE NAVIGATION SYSTEM

(a) Refer to Navigation System Problem Symptoms Table.

Result:





B -- Go to NAVIGATION SYSTEM (FOLLOW THE NAVIGATION SYMPTOM CHART TO PERFORM TROUBLESHOOTING)
A -- Continue to next step.

8. PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table Problem Symptoms Table.

Result:





B -- Go to step 10
A -- Continue to next step.

9. BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW

(a) Terminals of ECU Rear View Monitor System (w/o Wide View Front Monitor System).

NEXT -- Continue to next step.

10. CIRCUIT INSPECTION

NEXT -- Continue to next step.

11. ADJUST, REPAIR OR REPLACE

NEXT -- Continue to next step.

12. CONFIRMATION TEST

NEXT -- END