Camshaft Position Sensor: Service and Repair

Camshaft Position (CMP) Sensor - 3.5L GTDI





NOTE: Lower radiator hose removed for clarity.











Removal and Installation

Both sensors

1. Remove the Air Cleaner (ACL) outlet pipe and the ACL. For additional information, refer to Intake Air Distribution and Filtering Air Cleaner Air Cleaner Outlet Pipe.

RH sensor

2. Position the RH turbocharger intake tube aside. For additional information, refer to Intake Air System Components - Exploded View in Intake Air Distribution and Filtering Intake Air System Components - Exploded View.

LH sensor

3. Position the LH turbocharger intake tube aside. For additional information, refer to Intake Air System Components - Exploded View in Intake Air Distribution and Filtering Intake Air System Components - Exploded View.

Both sensors

4. Disconnect the Camshaft Position (CMP) sensor electrical connector.

5. Remove the bolt and the CMP sensor.
- To install, tighten to 10 Nm (89 lb-in).

6. NOTE: Lubricate the CMP sensor O-ring seal with clean engine oil.

To install, reverse the removal procedure.