After Repair Procedure

AFTER REPAIR PROCEDURE [FN4A-EL]

Caution:
^ After repairing a malfunction, perform the following procedure to verify that the malfunction has been corrected.
^ When performing this procedure, be sure to drive the vehicle at lawful speed and pay attention to the other vehicles.





1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
^ When using the IDS (laptop PC)
1. Select the "Toolbox" tab.
2. Select "SelfTest".
3. Select "Modules".
4. Select "PCM".
5. Select "Retrieve CMDTCs".
^ When using the PDS (Pocket PC)
1. Select "Module Tests".
2. Select "PCM".
3. Select "SelfTest".
4. Select "Retrieve CMDTCs".
3. Verify the DTC according to the directions on the M-MDS screen.
4. Press the clear button on the DTC screen to clear the DTC.
5. Perform the following DTC inspections to ensure that the DTCs have been resolved:

P0706-P0734:

P0741-P1783:

P0756-P0762:

P0767-P0894:

6. Gradually slow down and stop the vehicle.
7. Make sure that the repaired DTC does not recur.