Condenser HVAC: Service and Repair

CONDENSER REMOVAL/INSTALLATION[L3 WITH TC]

1. Disconnect the negative battery cable.
2. Discharge the refrigerant from the system. (See REFRIGERANT RECOVERY.) (See REFRIGERANT CHARGING [L3 WITH TC].)
3. Remove the shroud panel.

CAUTION: If moisture or foreign material enters the refrigeration cycle, cooling ability will be lowered and abnormal noise will occur. Always immediately plug all open fittings after removing any refrigeration cycle parts to keep moisture or foreign material out of the cycle.




4. Remove in the order indicated in the table. Do not allow compressor oil to spill.
5. Install in the reverse order of removal.
6. Perform the refrigerant system performance test. (See REFRIGERANT SYSTEM PERFORMANCE TEST[L3 WITH TC].)

Condenser Installation Note
1. When installing a new condenser, add a supplemental amount of ATMOS GU1O compressor oil inlet the refrigerant cycle.

Supplemental amount (approx. quantity) : 20 ml {20 cc, 0.7 fl.oz}