[2] Zero quantity calibration for the injector of cylinder 6: The minimum actuation period of the injector was not attained.

[2] Zero quantity calibration for the injector of cylinder 6: The minimum actuation period of the injector was not attained.


Possible cause:

- Zero quantity
Affected functions:

- Engine diagnosis

-------------------------------------------------

Test 1: Replace defective injector.

1. Replace defective injector.

Test 1.1: Test of compression

Test 1.2: Check the zero quantity calibration.

1.1. Test of compression
Test of compression
Test prerequisite

- Ignition ON
- Engine not running
NOTE RE Test of compression

- As of an rpm difference greater than 7 1/min between the lowest and the highest value, a mechanical compression test and cylinder leak test must be performed on all cylinders to locate the fault.
Continue to test with button F2

Warning!Communication with ECU required.


1.2. Check the zero quantity calibration.
Component Y76y6 (Fuel injector cylinder 6) is defective.
Tests conducted

- Compression test
Possible cause and remedy

- Replace component Y76y6 (Fuel injector cylinder 6).
Limit values

- Maximum limit value for calibration point 0:197micro s
- Minimum limit value for calibration point 0:-109micro s
- Maximum limit value for calibration point 1:17micro s
- Minimum limit value for calibration point 1:-119micro s
Important note

- Make a printout of the following screen page.
Communication with ECU required