13AB00

The supply voltage of control unit N3/9 (CDI control unit) is too low (undervoltage).


Possible cause:

- Supply voltage
Affected functions:

- Power generation

-------------------------------------------------

Test 1: Test voltage supply.

1. Test voltage supply.
Power supply Terminal (87)
Test prerequisite

- The actual value is not o.k.
Test sequence

- Check voltage supply at fuses 21, 22, 23 and 24.
- Measure direct voltage with multimeter between ground socket and socket N10/1f21 (Fuse 21)
- Measure direct voltage with multimeter between ground socket and socket N10/1f22 (Fuse 22)
- Measure direct voltage with multimeter between ground socket and socket N10/1f23 (Fuse 23)
- Measure direct voltage with multimeter between ground socket and socket N10/1f24 (Fuse 24)
- Switch on ignition.
Specified value

- Voltage[11...14] V
Question

- Is the measurement value OK?


YES
The measurement value is OK.Possible cause and remedy

- In the fault freeze frame data, check whether the power supply was OK at the time the fault occurred.
Battery voltage < 8 VIgnore fault code and erase fault memory.Battery voltage >= 8 VReplace control module N3/9 (CDI control unit).End of test

NO
The measurement value is not OK.Possible cause and remedy

- Check component N10/1kC (Circuit 87 relay, engine).
- Test wiring from component N3/9 (CDI control unit) to component N10/1 (Front SAM control unit with fuse and relay module) with an ohmmeter for short circuit (positive or negative) and repair, if necessary.
End of test