A - Work Instructions

A. Engine Mount, Mode1 124 and 201




As of February 1989 production, 2 mm higher front engine mounts were phased into production. To allow tension-free installation and correct positioning, the bottom of the motor mount has two grooves (arrow) and the front frame cross member has two corresponding tabs as of August 1989 production.

All models except 201.024, 201.028

The modified motor mounts may be installed in earlier production vehicles only after depleting stock of the previous version. When installing the new mounts, ensure that they are installed tension-free. Consult the parts m1crofiche for applicable part numbers.

Models 201.024, 201.028

In case of engine mount replacement, install only engine mount part no. 201 240 40 17 (see section "B" of this Service Information).

Note:
- Installation of the previous and modified engine mounts on the same vehicles is not permissible.

- When installing new engine mounts ensure that they are installed tension-free.

In Case of Warranty:
Time Allowance
See latest time guide microfiche

Damage Code

24 021 xx Front engine mount,
Fill in appropriate code for type of damage and add location code.