Automatic Transmission/Transaxle: Technical Service Bulletins
- Customer Interest
- All Technical Service Bulletins
- A/T - Clutch & Band Application Chart
- A/T - Choosing the Right ATF
- A/T - Math Part II
- A/T - Twenty Steps To Successful Repairs
- A/T - Math Formulas Part I
- A/T - Front Bushing Wear
- A/T - Slipping or No-Shift/Metal Sealing Rings
- A/T - Slipping or Soft Shifts
- A/T - Harsh Shifts or Erratic Shift Quality
- A/T - Valve Body Identification
- A/T - Slips or No Forward/ Slips In Reverse
- A/T - Rough Reverse Release
- A/T - Valve Body Assembly
- A/T - Modulator Application & Pressure Specifications
- A/T - How To Use A Pressure Gauge
- A/T - Engine Vacuum Testing
- A/T - Special Piston Removal/Installation Tool
- A/T - Piston Removal/Installation Tool
- A/T - Sudden Harsh Engagement in Reverse
- A/T - Sudden, Harsh Engagement in Reverse
- Intermittent Buzzing, Light Load, 2-3 Upshift
- A/T - Harsh and Dual Engagement/Noise, Shudder
- Transmission Noise Coasting or in Reverse
- Unusual Shift Characteristics After A/T Replacement
- A/T - Standardized Design Control Pressure Cable
- A/T - Modifications and Innovations
- A/T - Vacuum Modulator Adjustment
- A/T - Circumstances for Modulating Pressure Test
- A/T - LImited Production Automatic Brake Band Adjustment
- A/T - Test Sheets MY 90-91
- Engine Overrev Damage in Vehicles with Auto. Trans.
- A/T - No 2-3 Upshift at Full Throttle/Engine Cutout
- A/T - Harsh Shifts into D & R/Chattering out of D & R
- Vibration or Chatter During Shifting
- Harsh Shift Quality Under Partial Load Conditions
- Soft and Delayed Upshifts at Partial Load
- A/T - Humming Noise When Shifting to Reverse
- Noises in Stop and Go Traffic Between 12 and 30 MPH
- No Down Shifting From 4-3 or 3-2 at Times
- Early Kickdown Shifts/Delayed or No Downshifts
- Vehicle - New Dealer Technical Bulletin
- Maintenance - Factory Approved Service Products
- Transmission Fluid Dark or Black Does Not Smell Burned
- A/T - Double Engagement When Shifted Into Drive
- A/T - Shift Interlock Inspection During PDI
- Whistle Noise (Oil Flow Noise) in Reverse
- Harsh 2-1 Downshift
- Transmission Locks Up in Reverse
- A/T - Hard 2-1 Downshift When Starting Off
- A/T - Delayed Engagement Into Reverse
- A/T - Shift Complaints After Changing Large Plate Gasket
- A/T - Transmission Does Not Shift Out of 1st Gear
- Transmission Slips When Setting Off in First Gear
- Hard 4-3 Downshift at Approximately 60-70 km/h
- Harsh 4-3 Downshift at Approx. 35-45mph
- Harsh 4-2 or 3-2 Downshift, Accelerating Below 22mph
- Harsh 1-2 Shift After Cold Start
- A/T - Transmission Slips Starting Off in 1st Gear
- No Engagement in Any Forward Gear
- Delayed 2-3 Shifting
- A/T - Harsh Transmission Engagement in Rev.
- A/T - Upshift Only at Very High rpm When Cold