Procedure
1. Disconnect and cover battery negative terminal.
2. Remove left front floor mat/carpeting.
3. Remove cover on left front rocker panel.
4. Remove both covers under left side of instrument panel.
5. Remove cover on lower area of left A-pillar.
6. Remove left knee bolster.
7. Remove air hoses for left air vent, defroster vent and door vent.
8. Remove accelerator pedal.
Figure 2:
9. Remove panel on left side of center console.
10. Remove instrument cluster.
11. Remove cover of fuse/relay box, then release fuse carrier (a) and lift upwards (Figure 2).
Figure 3:
12. Attach connector block (X30) on left side of driver's footwell area. The mounting holes are already present (Figure 3).
Figure 4:
Figure 5:
14. Reattach fuse carrier.
15. Close fuse/relay box.
16. Route connector block harness with two connections to instrument cluster opening and connect brown wire to ground location (W1, Figure 5).
Figure 6:
17. Route grey/blue wire further under instrument panel along main vehicle harness to the center console and attach with electrical tape (Figure 6).
Figure 7:
18. Connect grey/blue wire to terminal block (X6, Figure 7).
19. Reinstall instrument cluster.
20. Reconnect battery negative terminal.
21. Using a voltmeter, verify wiring and operation of connector block.
Figure 8:
Figure 9:
CONNECTION, CONDITION AND NOMINAL VALVE
Connection Condition Nominal value
3 (circuit 31) and 5 (circuit 15R) Ignition/starter switch position 1 Battery voltage
3 (circuit 31) and 4 (circuit 58d) Parking lamps switched on Battery voltage
3 (circuit 31) and 2 (circuit 15) Ignition/starter switch position 2 Battery voltage
3 (circuit 31) and 1 (circuit 30) ---- Battery voltage
22. Reinstall panel on left side of center console.
23. Reinstall accelerator pedal.
24. Reinstall air hoses for left air vent, defroster vent and door vent.
25. Reinstall left knee bolster.
26. Reinstall cover on lower area of left A-pillar.
27. Reinstall both covers under left side of instrument panel.
28. Insert left front floor mat/carpeting.
Figure 10:
Connector block harness connections
Wiring diagram
W1 Main ground (behind instrument cluster)
X6 Terminal block, circuit 58d
F1 Fuse and relay box
X30 Connector block for accessory equipment