Computers and Control Systems: Technical Service Bulletins
- Customer Interest
- By Symptom
- Customer Interest
- Driveability
- Engine - Stalls Then Restarts/Cuts Out During Coasting
- Engine - Hesitates/Cuts Out/Quits/Difficult to Start
- Engine Hesitates, Cuts Out, Hard Start
- Idle Speed at Times Too High or Low
- Engine Cuts-Out, Cannot Be Restarted
- On-Off Ratio Won't Adjust After Repair, MIL on
- Engine Surges at Idle at Operating Temp.
- Erratic Operation
- Erratic Shifting
- Inoperative
- Out of specification
- Poor performance
- Starting problems
- All Technical Service Bulletins
- Engine Control - Engine Control Module (N3/10) Flashing
- Cruise Control Inoperative
- Hand-Held Tester (HHT) - Updated Modules
- Policy - HHT Warranty & Precautions
- Scan Tool (Impulse Counter ) - Failure, Improper Hook-Up
- Policy - Fluke Meter Approved
- Battery Discharged/Electronic Damage - After Jump Start
- Engine - Stalls Then Restarts/Cuts Out During Coasting
- Engine - Hesitates/Cuts Out/Quits/Difficult to Start
- Engine Hesitates, Cuts Out, Hard Start
- Control Unit - (CIS-E) On/Off Ratio Test/Impulse Readout
- Idle Speed at Times Too High or Low
- Idle Speed is Uneven
- Hestation During Acceleration or Poor Idle
- MIL ON ON/OFF Ratio Unadjustable After Repair Work
- Engine Cuts-Out, Cannot Be Restarted
- On-Off Ratio Won't Adjust After Repair, MIL on
- Engine is Difficult to Start, Cold or Warm
- Engine Does Not Start
- Engine - Difficult to Start Cold and Warm
- Engine Surges in Idle at Operating Temperature
- Engine - Cuts Out When Stopping/Intermittent Idle Surge
- Engine Surges at Idle at Operating Temp.