Preparation For Test

Special Tools:

Special Tools:

SPECIAL TOOLS
NOTE: Some or all of the special tools shown in the image are required to perform these testing procedures. If Mercedes special tools are not available, select tools may be substituted with an aftermarket equivalent.

Additional Tool
Suggested Multimeter Fluke Models 23, 83, 85, 87 or Sun DMM-5

PREPARATION FOR TEST
1. Ignition: OFF.
2. Remove base module (N16/1).
3. Install socket box and test harness according to connection diagram.

NOTES:
a. When performing test and adjustment work, the engine rpm should only be raised using the accelerator pedal. If the engine speed is raised via the control linkage in the engine compartment, the "limp-home" mode will become active and will be registered in the electronic accelerator malfunction memory as a fault. The Acceleration Slip Regulation (ASR) malfunction indicator lamp will also come on.
b. Note regarding "Test Connection" column:
The numbers indicated in parentheses, for example, (1.28) signify:
1 = Connector 1 in wiring diagram
23 = Socket 28 in wiring diagram