Installing In-Dash Controller (IDC)

Installing In-Dash Controller (IDC)

Installation

1. Disconnect and cover negative battery terminal.






2. Remove two screws securing false back to eyeglass compartment. Remove false back to expose two 12-pole connectors and one microphone connector. Remove cables from false back. False back and original mounting screws may be discarded.

3. Install IDC mounting bracket. Position mounting bracket so that mounting holes align with two false back mounting holes. Secure bracket with four M4 x 10 mm self tapping screws (the two additional holes have pre-punched bosses).






4. Connect two 12-pole connectors to in-dash controller. Connect microphone connector to connection on top center of controller.






5. Secure left cable and microphone cable to clips on back of IDC. Slide in-dash controller into bracket and snap into place - DO NOT PRESS ON THE LCD DISPLAY