1.0 (Entire System)

Preparation for Test:
1. Provide access to PSE control module (A37), disconnect white RHR pneumatic line with socket from PSE control module.
2. Connect tester to disconnected socket using connector 202 805 03 44.


NOTE: If an actuator does not operate correctly and no leakage is found, check the respective lines for links or blockages.


Parts Required for Test:
1 Connector 202 805 03 44
2 Rubber hose, 50 mm long 007 997 61 82
1 Pneumatic line, 1 m long 000 158 14 35


NOTE: The connections on the PSE control module and pneumatic multiple connector are marked with their German acronyms. In other words:
ZV (German) = CL (English),
SRU (German) = MVA (English),
OSL (German) = OSB (English).

Step 1.0: