Pneumatic Multiple Connector Test - Section 33

NOTE: The pneumatic multiple connector was eliminated as of 03/94.

Preparation For Test:
1. Pry off all pneumatic lines from pneumatic multiple connector (using a 7 mm open end wrench).
2. Plug all connections on the upper side of the pneumatic multiple connector with plugs (part no. 124 805 02 44).
3. Connect vacuum/pressure tester to the bottom side of the pneumatic multiple connector to test the individual connections
ZV, RH, FKS, SFG, PU

Parts Required for Test:
15 Plugs 124 805 32 44
1 Connector 129 805 34 44


NOTE: The connections on the PSE control module and pneumatic multiple connector are marked with their German acronyms. In other words:
ZV (German) = CL (English),
RH (German) = BA (English),
FKS (German) = RHR (English),
SFG (German) = RTG (English),
PU/P + (OSL) (German) = PU/P + (OSB) (English),
PU/P- (SRU) (German) = PU/P- (MVA) (English).

Special Tools:

Test Steps 1.0 & 2.0: