Wiper Motor Linkage: Service and Repair

Preliminary work:
Wiper system removed, refer to "Replacing Wiper System". Service and Repair






Removal
Wiper head (arrows)
mark (if no marking provided).

Linkage (1)
press off.

Linkage (2)
press off.

Nut (3) of wiper shaft
unscrew.

Swivelling lever (4)
press off.

Installation

NOTE: Wiper motor must be in park position. Connect to cable at wiper system relay (K26) if necessary and run to park position.

Swivelling lever (4)
press on.

Linkage (1)
press on.

Linkage (2)
press on as shown in figure.

NOTE: Markings on wiper head (arrows) must be aligned. Wiper motor in park position. The points "A" should form a line. Adjust wiper motor if necessary.

Swivelling lever (4)
tighten with nut (3).