B. Mounting (PSE) & Linear Compensator

B. Mounting the portable support electronics (PSE) and linear compensator

1. In the right rear quarter panel area, locate the:

^ 25-pole D-connector

^ coaxial cable from the front center console (C, Figure 6)

^ fiber optic connector

^ integrated bumper antenna cable (A, Figure 6)

^ 4-pole antenna switch connector

Note:
It is possible cable connectors are behind the amplifier.





2. Mount the linear compensator to the installation bracket with four M4 x 10 screws positioning compensator so the receptacle for the green 14-pole connector faces the bracket side with the mounting tab (A, Figure 1).

3. Mount the PSE to the installation bracket with four M4x6 screws (B, Figure 1).

NOTICE
DO NOT use screws longer than those described in Step 3. PSE damage will otherwise result.

4. Connect the 25-pole female side of the telephone Y-cable to the PSE and gently hand-tighten the retaining screws.

5. Connect the green 14-pole connector to the linear compensator.





6. Mount the antenna switch to the back of the installation bracket with two M4 x 6 screws (Figure 2).

7. Connect the antenna switch cable labeled "Booster" to the linear compensator jack labeled Antenna."