P203F

B28/6 (Pressure sensor upstream of throttle valve)

Test 1: Check component B28/6 (Pressure sensor upstream of throttle valve).

1. Check component B28/6 (Pressure sensor upstream of throttle valve).
Note

- Components B28/4. B28/5. B28/6. and B28/7 are identical in design and differentiated by a colored marking.
ComponentB28/4 (Pressure sensor downstream of air cleaner, left cylinder bank)/B28/5 (Pressure sensor downstream of air cleaner, right cylinder bank)

- Marking 'Green'
ComponentB28/6 (Pressure sensor upstream of throttle valve)/B28/7 (Pressure sensor downstream of throttle valve)

- Marking 'Blue'
Continue with button F2

Test 1.1: Check component B28/6 (Pressure sensor upstream of throttle valve) using actual value.

Test 1.2: Test signal voltage of component B28/6 (Pressure sensor upstream of throttle valve).

Test 1.3: Check power supply of component B28/6 (Pressure sensor upstream of throttle valve).

1.1. Check component B28/6 (Pressure sensor upstream of throttle valve) using actual value.
Warning!Communication with ECU required.


1.2. Test signal voltage of component B28/6 (Pressure sensor upstream of throttle valve).
Test prerequisite

- The power supply of component B28/6 (Pressure sensor upstream of throttle valve) is OK.
Test sequence

- Switch off ignition.
- Connect socket box (126-pin) to component N3/10 (ME-SFI [ME] control unit).
- Measure direct voltage with multimeter between sockets [3.4] 37 and (2.08) 17 of the 126-pole socket box tester.
- Switch on ignition.
Specified values

- Ignition ON: [1.7...2.1] V
- Engine at idle: [1.7...2.1] V
Question

- Are the measurement values OK?


YES
The measurement values are OK.End of test

NO
The measurement values are not OK.Possible cause and remedy

- Lines to component B28/6 (Pressure sensor upstream of throttle valve)
- B28/6 (Pressure sensor upstream of throttle valve)
End of test

1.3. Check power supply of component B28/6 (Pressure sensor upstream of throttle valve).
Test prerequisite

- The actual value is not o.k.
- The power supply of component N3/10 (ME-SFI [ME] control unit) is OK.
Test sequence

- Switch off ignition.
- Detach coupling at component B28/6 (Pressure sensor upstream of throttle valve).
- Measure direct voltage with multimeter between sockets (B28/6) 1 and (B28/6) 3
- Switch on ignition.
Specified value

- Voltage[4.75...5.25] V
Question

- Is the measurement value OK?


YES
The measurement value is OK.Further possible causes of fault

- Test signal voltage of component B28/6 (Pressure sensor upstream of throttle valve).
End of test

NO
The measurement value is not OK.Possible cause and remedy

- Lines to component N3/10 (ME-SFI [ME] control unit)
- N3/10 (ME-SFI [ME] control unit)
End of test