Operation CHARM: Car repair manuals for everyone.
Home >> Mercedes Benz >> 2003 >> SLK 230 (170.449) L4-2.3L SC (111.983) >> Repair and Diagnosis >> A L L Diagnostic Trouble Codes ( DTC ) >> Testing and Inspection >> P Code Charts >> P0600 >> [1] CAN Message From Control Module N15/3 (ETC Control Module): CAN Signal Faulty >> Test 1: Engine Compartment CAN Test >> Test 4: Resistance Test of Engine Compartment CAN >> Test 4A: Test Total Resistance of Engine Compartment CAN >> Test 4A2: Perform Measurement at Component N3/10 (ME-SFI Control Module)

Test 4A2: Perform Measurement at Component N3/10 (ME-SFI Control Module)



Perform measurement at component N3/10 (ME-SFI control module)

Test total resistance of the CAN engine

Test sequence
- Switch off ignition.
- Connect socket box to component N3/10 (ME-SFI control module).
- (4.1) 86<-->87 (4.2)

Specified value
- Resistor [55...65]

Question: Is the measured value okay?

No
- The measured value is not o.k.
Possible cause and remedy
- Cable from component N3/10 (ME-SFI control module) to component X63/4 (CAN databus adapter connector, 2-pin)
- Test terminating resistor of component X63/4 (CAN databus adapter connector, 2-pin).
- Test terminating resistor of CAN element in control module N3/10 (ME-SFI control module).
**End of test**

Yes
- The measured value is o.k.
**End of test**


pro multis · About Operation CHARM