Center Mounted Brake Lamp: Service and Repair

AR82.10-P-5375P Remove/Install Center High-Mounted Stop Lamp

Shown On Model 203.0:

1 Remove paneling from inside of trunk
2 Unscrew bolts from the retaining clamps of the center high-mounted stop lamp (E21)
3 Push center high-mounted stop lamp (E21) out of trunk lid
4 Disconnect connector of center high-mounted stop lamp (E21x1)
5 Remove retaining clamps (1)
6 Screw retaining clamps (1) to center high-mounted stop lamp (E21)

NOTE: When replacing center high-mounted stop lamp it is supplied with new clamps

7 Attach connector of center high-mounted stop lamp (E21x1)
8 Insert center high-mounted stop lamp(E21)

CAUTION:
- Ensure that seal is in good condition and properly seated Apply sliding compound
- Do not allow retaining clamps to damage paintwork.

NOTE: Ensure that retaining brackets are correctly seated. Retaining brackets must be able to be pushed together when fitted

9 Perform function check
10 Install hazard warning triangle