B. Mounting the Linear Compensator and MHI Control Module to Bracket

1. Mount the linear compensator to the bracket front by sliding the compensator base under the clip (A, Figure 2) and then fastening the opposing side with two M3.5 x 8 self-tapping screws (B, Figure 2).

Note:
Position the linear compensator with the connector receptacles facing the direction of the bracket mounting arm (Figure 2).





2. Mount the MHI control module to the threaded studs on the bracket backside with four M4 hex nuts (Figure 3).

Note:
The keyed threaded studs fit the MHI control module only one way (i.e. it is not possible to incorrectly mount the MHI control module to the bracket).