AZ54.65-P-0001-06M Route Wiring Harness And Connect

AZ54.65-P-0001-06M Route Wiring Harness And Connect
- Model 203.0## 1##






1 Ultrasonic PTS wiring harness
62 18-pin connector for EPH ultrasonic control module
N10/2 6-pin blue connector, rear SAM control module with fuse and rear module
X35/29 Black 8-pin connectors for EPH ultrasonic rear bumper
X35/37 White 6-pin connector for rear warning indicator






1b warning indicator wiring harness

1 18-pin connector is connected when installing ultrasonic PTS control module (62).
2 Route tieout for ultrasonic backup assist wiring harness (1) with 6-pin white warning indicator connector to left C-pillar to rear along present lead and to rear warning indicator connector (X35/37) and fasten.






3 Route tie-out with 6-pin blue connector to rear SAM control module with fuse and relay module (N10/2) and connect to plug location marked in blue (see magnified section).
The plug locations are protected against polarity reversal. Fasten tie-out to present leads with two cable straps.

4 Route tie-out for ultrasonic backup assist wiring harness (1) with 8-pin connector to cargo threshold through left side compartment along present leads and fasten.






5 Route tieout for ultrasonic backup assist wiring harness (1) to right side of vehicle below cargo threshold along present leads and fasten with four cable straps.
6 Connect ultrasonic backup assist wiring harnesses (1) and ultrasonic sensors (X35/29).






7 Install rear SAM control module with fuse and relay module (N10/2)
8 Fit fuse 13 (N10/2f13) with a 5A fuse.
Check whether relay 1 circuit 15R (N10/2kF) is inserted in plug location F, if not, connect relay 1