B1617

DTC B1617: Roll Over Sensor Malfunction

CAUTION:
If DTCs is set in the SRS-ECU, always diagnose the CAN main bus line.

TROUBLE JUDGMENT

The above DTC is set if an abnormality is detected in the circuit inside the SRS-ECU.

TROUBLESHOOTING HINTS

Malfunction of the SRS-ECU

DIAGNOSIS

STEP 1. Using scan tool MB991958, diagnose the CAN bus line

(1)
CAUTION:
To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.

Connect scan tool MB991958. Refer to "How to connect the scan tool Reading and Clearing Diagnostic Trouble Codes."

(2)Turn the ignition switch to the "ON" position.

(3)Diagnose the CAN bus line.

(4)Turn the ignition switch to the "LOCK" (OFF) position.

Q. Is the CAN bus line found to be normal?

YES Go to Step 2.
NO Repair the CAN bus line. CAN Bus Diagnostics Chart).
STEP 2. Recheck for diagnostic trouble code.

Check again if the DTC is set.

(1)Turn the ignition switch to the "ON" position.

(2)Check if the DTC is set.

(3)Turn the ignition switch to the "LOCK" (OFF) position.

Q. Is the DTC output regardless of "Active" or "Stored" faults?

YES Replace the SRS-ECU (Refer to Service and Repair).
NO There is an intermittent malfunction such as poor engaged connector(s) or open circuit How to Cope With Intermittent Malfunctions).