Alignment - 4 Wheel Steering Rear Camber/Toe
NO.: TSB-92-37B-001DATE: November, 1992
MODEL: 91-92 GALANT VR4, 91-93 3000GT VR4
SUBJECT:
4 WHEEL STEERING - REAR WHEEL ALIGNMENT
PURPOSE
When adjusting camber and toe-in on 3000GT VR4 vehicles you MUST first disconnect the 4-wheel steering tie rod ends from the trailing arms. If the tie-rod ends are not disconnected, the 4-wheel steering system will restrict the amount of toe adjustment and alter the alignment angles. Use the following procedure when performing a rear wheel alignment.
1. Disconnect the 4-wheel steering tie rod ends from the trailing arm.
2. Adjust camber and toe-in as described in the service manual. Write down the final readings.
3. Reconnect the 4-wheel steering tie rod ends to the trailing arm.
4. Adjust the tie-rod ends to match the previous toe-in readings.
CAUTION:
Failure to disconnect 4-wheel steering tie rod ends before adjustment may cause damage to the rear wheel alignment adjustment cams and cause pressure on the 4-wheel steering system. Also the alignment angles will be seriously altered if the tie-rod length is not correct.