Clutch: Service and Repair

REMOVAL
Follow removal steps outlined in illustration. Manual Transmission/Transaxle

NOTE: The modular clutch assembly (Clutch & flywheel assembly) used in this vehicle consists of a single, dry-type clutch disc and a diaphragm style clutch cover. The clutch unit is serviced as an assembly. No disassembly is possible.

INSPECTION
Clutch & Flywheel Assembly
1. Check clutch assembly for contamination (dirt, oil). Replace clutch assembly, if required.
2. Check to see if the clutch disc hub splines are damaged. Replace with new clutch assembly, if necessary.
3. Check for uneven wear on clutch fingers.
4. Check for broken clutch cover diaphragm spring fingers. Replace with new clutch assembly, if necessary.

Clutch Release Bearing
Check to see if the release bearing is sticky or binding. Replace bearing, if needed.

Clutch Release Lever/Clutch Control Equip Stud
1. Check linkage for excessive wear on the pivot stud and fork fingers.
2. Replace all worn parts.

INSTALLATION
Installation in reverse order as removal.

NOTE: Installation service points as follows:





A. Grease application to clutch release. (5)
Specified grease: MITSUBISHI genuine grease Part No. 0101011 or equivalent.
B. Clutch & flywheel assembly installation. (3)
1. Apply specified grease to clutch disc splines and squeeze it in place with a brush.
Specified grease: MITSUBISHI genuine grease Part No. 0101011 or equivalent.