Procedure For Input of Security Code For Anti-Theft System

The radio, tape player, CD player and CD auto changer do not work under the following conditions:
- Power supply to the radio, tape player, CD player and CD auto changer has been suspended for more than an hour continuously by removing the cable from the battery terminal or disconnecting the harness connectors.
- The power supply to the radio, tape player, CD player and CD auto changer has been suspended for more than an hour due to a blown fuse or discharged battery.
- The radio, tape player, CD player and CD auto changer has been replaced.

If the radio, tape player, CD player and CD auto changer does not work for these conditions, enter the security code as follows:




1. Confirm the security code using any of the following methods.
1. Use the security code indicated on the cards retained in the vehicle.




2. If the security code is unknown owing to the owner's loss of the card:
a. Remove the radio, tape player, CD player and CD auto changer.
b. Read the serial number stamped on the radio, tape player, CD player and CD auto changer.
c. Look up the security code (anti-theft code table) corresponding to the serial number.




3. When the radio, tape player, CD player and CD auto changer is replaced:
Use the security code on the cards attached to the upper surface of the replacement radio, tape player, CD player and CD auto changer.

NOTE: Deliver the two cards to the owner.




2. Connect the radio to the vehicle harness.
3. Turn the ignition key to the "ACC" or "ON" position.
4. Press the "PWR" button, and "codE" will be displayed.




5. Press number 1 through number 4 memory select button to set the four-digit security code shown on the card. Every time each digit key is pressed, the figure changes as follows: 0->1->2->3->4->5->6->7->8->9->0
6. Press the "TAPE" button (type 1 and 3) or "CD" button (type 2) button, and a beep will be heard. If entered correctly, the radio and tape player will work.
7. If the security code is not accepted, "1 Err" is displayed. In a few seconds, it will change to "codE." Then repeat steps 5 and 6.

NOTE: The anti-theft system will allow three attempts maximum to input the correct code.

NOTE: The second error is displayed as "2 Err" When the third error is made, "3 Err" is displayed and then the display changes to "OFF" If this should occur, the unit will not work any more.

NOTE: To input the security code again, turn the ignition switch to the "ACC" or "ON" position and wait for one hour when "OFF" is displayed. After "OFF" disappears on the display, press the "PWR" button and "codE" will be displayed. The security code can be input again.




Three-minute operation mode
To facilitate replacement or check, the radio, tape player, CD player and CD auto changer can be operated for three minutes without inputting the security code.
1. Press the "PWR" button and "EJECT" button together to operate the radio, tape player, CD player and CD auto changer.
2. In three minutes the unit will not be able to work. Then the radio, tape player, CD player and CD auto changer will be switched off.