Flywheel: Specifications
Note: The content of this article/image reflects the changes called out by TSB - 04-11-002DRIVE PLATE BOLT/FLYWHEEL BOLT INSTALLATION
1. Remove all the remaining sealant from bolts and thread holes of crankshaft.
2. Apply engine oil to the flange of bolt.
3. Apply engine oil into the thread holes of crankshaft.
4. Apply 3M AAD part number 8672 or equivalent to the drive plate bolt or flywheel bolt.
5. Tighten the bolts to specified torque.
Tightening torque: 98 ± 5 Nm (72 ± 3 ft. lbs.)