Air Bag(s) Arming and Disarming: Service and Repair

Precautions for SRS "AIR BAG" and "SEAT BELT PRE-TENSIONER" Service

- Before servicing the SRS, turn ignition switch "OFF", disconnect both battery cables and wait at least 3 minutes.

For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.

- Do not use electrical test equipment to check SRS circuits unless instructed.

For final checking after repairing SRS without using CONSULT-II, go to Diagnostic Procedure 1 [1][2]Component Tests and General Diagnostics

For final checking after repairing SRS by using CONSULT-II, go to Diagnostic Procedure 3. Diagnostic Procedure 3