Audio

AUDIO

System Description

BASE AND MIDLINE SYSTEM
Refer to Owner's Manual for audio system operating instructions.

Power is supplied at all times
- through 15 A fuse [No. 31, located in the fuse and fusible link box]
- to audio unit terminal 6.

With the ignition switch in the ACC or ON position, power is supplied
- through 10 A fuse [No. 6, located in the fuse block (J/B)]
- to audio unit terminal 10.

Ground is supplied through the case of the audio unit.

Audio signals are supplied
- through audio unit terminals 1, 2, 3, 4, 13, 14, 15, and 16
- to terminals + and - of front door speaker LH and RH
- to terminals + and - of rear door speaker LH and RH
- to terminals + and - of tweeter LH and RH.

BOSE(R) SYSTEM
Refer to Owner's Manual for audio system operating instructions.

Power is supplied at all times
- through 15 A fuse [No. 31, located in the fuse and fusible link box]
- to audio unit terminal 6, and
- to Bose speaker amp. terminal 1.

With the ignition switch in the ACC or ON position, power is supplied
- through 10 A fuse [No. 6, located in the fuse block (J/B)]
- to audio unit terminal 10.

Ground is supplied through the case of the audio unit.

Ground is also supplied
- to speaker amp. terminal 17
- through body ground B117.

Audio signals are supplied
- through audio unit terminals 1, 2, 3, 4, 13, 14, 15, and 16
- to speaker amp. terminals 23, 24, 25, 26, 27, 28, 29, and 30.

Audio signals are amplified by the speaker amp.

The amplified audio signals are supplied
- through speaker amp. terminals 2, 3, 9, 10, 11, 12, 13, 14, 15, 16, 18, and 19
- to terminals + and - of front door speaker LH and RH
- to terminals + and - of rear door speaker LH and RH
- to terminals + and - of tweeter LH and RH
- to terminals + and - of subwoofer LH and RH.

Satellite Radio Tuner (Pre-Wiring)
The satellite radio tuner pre-wiring allows connection of a satellite radio tuner.

Power is supplied at all times
- through 15 A fuse (No. 31, located in the fuse and fusible link box)
- to satellite radio tuner pre-wiring terminal 32.

With the ignition switch in the ACC or ON position, power is supplied
- through 10 A fuse [No. 6, located in the fuse block (J/B)]
- to satellite radio tuner pre-wiring terminal 36.

Ground is supplied through the case of the satellite radio tuner.

Audio signals are supplied
- through satellite radio tuner pre-wiring terminals 21, 22, 23, and 24
- to audio unit terminals 41, 42, 43, and 44. Satellite Radio Tuner (Factory Installed)

Satellite Radio Tuner (Factory Installed)

NOTE: Factory installed satellite radio systems may be identified by the location of the satellite radio tuner antenna.Factory installed satellite radio antennas are installed at the rear center of the roof. Dealer installed antennas may be installed anywhere on the roof.

Power is supplied at all times
- through 15 A fuse (No. 31, located in the fuse and fusible link box)
- to satellite radio tuner terminal 32.

With the ignition switch in the ACC or ON position, power is supplied
- through 10 A fuse [No. 6, located in the fuse block (J/B)]
- to satellite radio tuner terminal 36.

Ground is supplied through the case of the satellite radio tuner.

Then audio signals are supplied
- through satellite radio tuner terminals 21, 22, 23, and 24
- to audio unit terminals 41, 42, 43, and 44.

SPEED DEPENDENT VOLUME CONTROL
If activated, the radio output volume will be automatically adjusted to compensate for increased driving noises at higher driving speeds. The radio receives a vehicle speed signal from the combination meter, and selects the output volume.

STEERING WHEEL AUDIO CONTROL SWITCHES (MIDLINE AND BOSE SYSTEM)
When one of the steering wheel audio control switches is pushed, the resistance in steering switch circuit changes depending on which button is pushed.