Crash Zone Sensor

CRASH ZONE SENSOR

Removal and Installation

CAUTION:
- Before servicing the SRS, turn ignition switch OFF, disconnect negative and positive battery cables, then wait at least 3 minutes.
- Do not insert any foreign objects (screwdriver, etc.) into crash zone sensor or harness connectors.
- Do not attempt to disassemble crash zone sensor.

REMOVAL
1. Disconnect negative and positive battery cables, then wait at least 3 minutes.




2. Remove front grille.
3. Disconnect crash zone sensor connector.
4. Remove crash zone sensor nuts.

CAUTION: Replace crash zone sensor if it has been dropped or sustained an impact.

INSTALLATION
Installation is in the reverse order of removal.
- After the work is complete, perform self-diagnosis to check that no malfunction is detected. Refer to SRS- 20, "SRS Operation Check" . [1][2]Component Tests and General Diagnostics

CAUTION:
- Check crash zone sensor for proper installation.