Wheel Sensors

Removal and Installation

BRC-235 COMPONENT:

CAUTION:
^ Be careful not to damage wheel sensor edge and sensor rotor teeth.
^ When removing the front or rear wheel hub assembly, first remove the wheel sensor from the assembly. Failure to do so may result in damage to the wheel sensor wires making the sensor inoperative.

CAUTION:
^ Pull out the wheel sensor, being careful to turn it as little as possible. Do not pull on the wheel sensor harness.
^ Installation should be performed while paying attention to the following, and then tighten bolts and nuts to the specified torque.
- Check if foreign objects such as iron fragments are adhered to the pick-up part of the sensor or to the inside of the hole for the wheel sensor, or if a foreign object is caught in the surface of the mating surface for the rotor. If something wrong is found, fix it and then install the wheel sensor.

REMOVAL

Front
1. Remove wheel and tire using power tool.
2. Partially front wheel fender protector.
3. Remove wheel sensor bolt and wheel sensor.
4. Remove harness wire from mounts and disconnect wheel sensor harness connector.

Rear

NOTE: Both rear wheel sensors share one harness and must be replaced as an assembly.

1. Remove wheel and tire using power tool.
2. Remove wheel sensor bolts and wheel sensors from both rear wheels.
3. Remove harness wire from mounts and harness wire clips from suspension member.





4. Disconnect wheel sensor harness connector (1).

INSTALLATION
Installation is in the reverse order of removal.
^ When installing wheel and tire, refer to WT-37, "Adjustment". Service and Repair