Alternator: Service and Repair

ON-VEHICLE REPAIR

GENERATOR

Removal and Installation

QR25DE

Removal
1. Disconnect the battery cable from the negative terminal.
2. Remove engine side undercover, using power tools.
3. Remove drive belt.
4. Remove engine room cover.
5. Remove "B" terminal nut.
6. Disconnect generator connector.
7. Remove generator ground harness bolt.
8. Remove generator bolts, using power tools.
9. Remove generator assembly upward.




Installation
Installation is in the reverse order of removal.

CAUTION:
Be sure to tighten "B" terminal nut carefully.
- Install generator and check tension of belt.

- For this model, the power generation voltage variable control system that controls the power generation voltage of the generator has been adopted. Therefore, the power generation voltage variable control system operation inspection should be performed after replacing the generator, and then make sure that the system operates normally. Refer to "System Description" in Charging System.