Changing

Changing
1. Remove drain plug, and then drain CVT fluid from oil pan.
2. Install drain plug to oil pan.

CAUTION: Do not reuse drain plug gasket.

3. Tighten drain plug to the specified torque.
4. Fill CVT fluid from CVT fluid charging pipe to the specified level.
5. With the engine warmed up, drive the vehicle in an urban area. When ambient temperature is 20°C (68°F), it takes about 10 minutes for the CVT fluid to warm up to 50 to 80°C (122 to 176°F).
6. Check CVT fluid level and condition.
7. Repeat steps 1 to 5 if CVT fluid has been contaminated.
CVT fluid: Refer to TM-440, "General Specification". General Specification
Fluid capacity: Refer to TM-440, "General Specification". General Specification

CAUTION:
^ Use only Genuine NISSAN CVT Fluid NS-2. Do not mix with other fluid.
^ Using CVT fluid other than Genuine NISSAN CVT Fluid NS-2 will deteriorate in driveability and CVT durability, and may damage the CVT, which is not covered by the NISSAN new vehicle limited warranty.
^ When filling CVT fluid, take care not to scatter heat generating parts such as exhaust.
^ Sufficiently shake the container of CVT fluid before using.
^ Delete CVT fluid deterioration date with CONSULT-III after changing CVT fluid. Refer to TM-293, "CONSULT-III Function (TRANSMISSION)". Consult-III Function (Transmission)