CVT: RE0F09B

DIAGNOSTIC PROCEDURE

SYMPTOM 1:
^ Selector lever cannot be moved from "P" position with ignition switch in ON position and brake pedal depressed.

SYMPTOM 2:
^ Selector lever can be moved from "P" position with ignition key in ON position and brake pedal released.

1.CHECK POWER SOURCE
1. Disconnect CVT device harness connector.





2. Turn ignition switch ON (Do not start engine).
3. Check voltage between CVT device harness connector M23 terminal 6 and ground.
Voltage:
Brake pedal depressed: Battery voltage
Brake pedal released: 0V
OK or NG
OK >> GO TO 4.
NG >> GO TO 2.

2.CHECK POWER SOURCE AT STOP LAMP SWITCH





1. Turn ignition switch OFF.
2. Disconnect stop lamp switch harness connector.
3. Turn ignition switch ON (Do not start engine).
4. Check voltage between stop lamp switch harness connector E38 terminal 3 and ground.
Voltage: Battery voltage
OK or NG
OK >> GO TO 3.
NG >> Check the following items for damage, repair or replace damaged parts:
^ 10A fuse [No. 3, located in the fuse block (J/B)].
^ Harness for open between ignition switch and stop lamp switch harness connector.
^ Ignition switch, refer to XX POWER SUPPLY ROUTING CIRCUIT.

3.CHECK STOP LAMP SWITCH








1. Turn ignition switch OFF.
2. Disconnect stop lamp switch harness connector E38.
3. Check continuity between stop lamp switch terminals 3 and 4.
OK or NG
OK >> Adjust stop lamp switch. Refer to XX BRAKE PEDAL - ADJUSTMENT.
NG >> Replace stop lamp switch.

4.CHECK GROUND CIRCUIT





1. Turn ignition switch OFF.
2. Check continuity between CVT device harness connector M23 terminal 6 and ground.
Continuity should exist.
OK or NG
OK >> Replace shift lock solenoid and park position switch assembly.
NG >> Repair open circuit in harness or connectors.