Shift Fork and Fork Rod
CASE AND HOUSINGTM-28 Exploded View:
SHAFT AND GEAR
TM-29 Exploded View:
^ Apply gear oil to gears, shafts, synchronizers, and bearings when assembly.
TM-30 Exploded View:
^ Apply gear oil to gears, shafts, synchronizers, and bearings when assembly.
SHIFT FORK AND FORK ROD
TM-31 Exploded View:
FINAL DRIVE
TM-32 Exploded View:
SHIFT FORK AND FORK ROD
Disassembly
1. Remove return spring to striking rod assembly
Assembly
1. Temporarily install return spring to striking rod assembly.
CAUTION: Be careful with the orientation of return spring.
2. Attach one end of the return spring to striking interlock of striking rod assembly while holding return spring.
CAUTION:
^ When installing, check that return spring is securely seated in the groove of striking interlock of striking rod assembly.
Inspection
STRIKING ROD ASSEMBLY AND RETURN SPRING
^ Check contact surfaces and sliding area for wear, damage, bending, etc. If necessary, replace parts.
FORK ROD AND SHIFT FORK
^ Check contact surfaces and sliding area for wear, damage, bending, etc. If necessary, replace parts.
SHIFT FORK
^ Check if the width of shift fork hook (sliding area with coupling sleeve) is within allowable specification below.