Removal and Replacement

FRONT REGULATOR

Exploded View

GW-19 Exploded View:

Removal and Installation

REMOVAL
1. Remove the front door finisher.




2. Remove the upper six outer door module bolts (A) and the two upper window regulator bolts (B).




3. Reconnect the power window switch

4. Raise/lower the door glass until the door glass bolts (A) can be seen.




5. Disconnect the window motor connector (A).




6. Raise the door glass and hold with a suction lifter (A).




7. Remove the door glass bolts (A).
8. Remove the door glass bolts and the door module assembly.

INSPECTION AFTER REMOVAL
Check the regulator assembly for the following items. If a malfunction is detected, replace or grease it.
- Excessive cable wear.




- Regulator channel deformation (A).




- Apply grease for each sliding part. Apply grease at the application points (A) as shown.

INSTALLATION
Installation is in the reverse order of removal. Reset Limit Switch after Installation: Setting of Limit Switch