Recall PC065 - Incorrect VECI Label Installed: Overview
Reference: NTB10-119Date: October 28, 2010
VOLUNTARY EMISSIONS RECALL CAMPAIGN
2011 ALTIMA 2.5 CALIFORNIA PZEV EMISSION LABEL
CAMPAIGN I.D. # PC065
APPLIED VEHICLE: 2011 Altima (L32 & CL32) Sedan & Coupe with 2.5 L engine
Check Service Comm to confirm campaign eligibility.
INTRODUCTION
Nissan has determined that some 2011 Altima vehicles with 4 cylinder engines were manufactured with an incorrect under-hood Vehicle Emission Control Information (VECI) label. The VECI label is a part of the emissions system certification, and an incorrect label is considered by CARB/EPA as a non-compliance situation. The VECI label is also an integral part of State emission testing. If the label is incorrect, the vehicle may subsequently fail that test even if it meets applicable emissions standards.
To remedy this, Nissan is conducting a voluntary emission recall campaign. A replacement label is being mailed to affected customers along with instructions on how to affix. Nissan is also offering customers an option of bringing their label to a dealer and have the dealer install it free of charge for parts or labor.
IDENTIFICATION NUMBER
Nissan has assigned identification number PC065 to this campaign. This number must appear on all communications and documentation of any nature dealing with this campaign.
DEALER RESPONSIBILITY
It is the dealer's responsibility to check Service Comm for the campaign status on each vehicle falling within the range of this voluntary recall which for any reason enters the service department. This includes vehicles purchased from private parties or presented by transient (tourist) owners and vehicles in a dealer's inventory. Nissan requires dealers to correct any new or used vehicles in their inventory before they are retailed.
SERVICE PROCEDURE
NOTE:
DO NOT REMOVE THE EXISTING VEHICLE EMISSION CONTROL INFORMATION (VECI) LABEL. Install the replacement label over the top of the existing label.
1. Park the vehicle in a safe place.
2. Set the transmission in "P" position and apply the parking brake.
3. Turn the ignition "OFF".
4. Open the engine hood and use the hood support rod to hold the hood open.
WARNING:
The engine compartment components may be extremely hot! Always allow sufficient time for cooling before performing any work under the hood.
5. Locate the existing under-hood VECI label.
6. Clean the label and the area around it with a mild detergent and water.
NOTE:
^ Care should be taken not to use harsh chemicals that may damage the existing label.
^ It is important the surface be free of dirt and oil to ensure proper adhesion of the new label.
7. Completely dry the label and the area around it.
8. Peel the new label from the backing sheet and install it directly over the top of the existing label.
NOTE:
The adhesive on the label is permanent. Extra care should be taken when applying the new label since it cannot be moved once it is attached.
PARTS INFORMATION
CLAIMS INFORMATION