With Intelligent Key System

DOOR LOCK ACTUATOR:_:REAR LH





Description
Locks/unlocks the door with the signal from BCM.




Component Function Check
1.CHECK FUNCTION
1. Use CONSULT-III to perform Active Test ("DOOR LOCK").
2. Touch "ALL LOCK" or "ALL UNLK" to check that it works normally.
Is the inspection result normal?
YES - Door lock actuator is OK.
NO - With Intelligent Key System.




Diagnosis Procedure
1.CHECK DOOR LOCK ACTUATOR INPUT SIGNAL
1. Turn ignition switch OFF.
2. Disconnect rear door lock assembly LH connector.
3. Check voltage between rear door lock assembly LH harness connector and ground.






Is the inspection result normal?
YES - Replace rear door lock assembly LH. Removal And Installation With Intelligent Key System.
NO - GO TO 2.
2.CHECK DOOR LOCK ACTUATOR CIRCUIT
1. Disconnect BCM connector and all door lock actuator connector.
2. Check continuity between BCM harness connector and rear door lock assembly LH harness connector.






3. Check continuity between BCM harness connector and ground.






Is the inspection result normal?
YES - Replace BCM. Removal And Installation.
NO - Repair or replace harness.