For Mexico

ELECTRICAL LOAD SIGNAL

Description

The electrical load signal (Headlamp switch signal, rear window defogger switch signal, etc.) is transferred through the CAN communication line.



Component Function Check


1. CHECK REAR WINDOW DEFOGGER SWITCH FUNCTION

1.Turn ignition switch ON.
2.Connect CONSULT and select "DATA MONITOR" mode.
3.Select "LOAD SIGNAL" and check indication under the following conditions.





Is the inspection result normal?
YES- GO TO 2.
NO- Go to "Diagnosis Procedure".

2. CHECK LIGHTING SWITCH FUNCTION

Check "LOAD SIGNAL" indication under the following conditions.





Is the inspection result normal?
YES- GO TO 3.
NO- Go to "Diagnosis Procedure".

3. CHECK HEATER FAN CONTROL SWITCH FUNCTION

Select "HEATER FAN SW" and check indication under the following conditions.





Is the inspection result normal?
YES- INSPECTION END
NO- Go to "Diagnosis Procedure".


Diagnosis Procedure


1. INSPECTION START

Confirm the malfunctioning circuit (rear window defogger, headlamp or heater fan). Refer to "Component Function Check".
Which circuit is related to the incident?
Rear window defogger-GO TO 2.
Headlamp-GO TO 3.
Heater fan-GO TO 4.

2. CHECK REAR WINDOW DEFOGGER SYSTEM

System Diagram.
- INSPECTION END

3. CHECK HEADLAMP SYSTEM

System Diagram (XENON TYPE) or System Diagram (HALOGEN TYPE).
- INSPECTION END

4. CHECK HEATER FAN CONTROL SYSTEM

Automatic Air Conditioning (automatic air conditioner) or Manual Air Conditioning
(manual air conditioner).
- INSPECTION END