Component Tests and General Diagnostics

FRONT SUSPENSION ASSEMBLY

Inspection and Adjustment


INSPECTION

Make sure the mounting conditions (looseness, back lash) of each component and component conditions (wear, damage) are normal.

LOWER BALL JOINT END PLAY

1.Set front wheels in a straight-ahead position. Do not depress brake pedal.
2.Place an iron bar or similar tool between upper link and steering knuckle.
3.Measure axial end play by prying it up and down.Front Suspension.

CAUTION:
Be careful not to damage ball joint boot. Do not damage the installation position by applying excessive force.

SHOCK ABSORBER

Check for oil leakage, damage and replace if malfunction is detected.

WHEEL ALIGNMENT

Description
Measure wheel alignment under unladen conditions.
NOTE:
"Unladen conditions" means that fuel, engine coolant, and lubricant are full. Spare tire, jack, hand tools and mats are in designated positions.
General Information and Recommendations
- A four-wheel thrust alignment should be performed.
- This type of alignment is recommended for any NISSAN vehicle.
- The four-wheel "thrust" process helps ensure that the vehicle is properly aligned and the steering wheel is centered.
- The alignment rack itself should be capable of accepting any NISSAN vehicle.
- The rack should be checked to ensure that it is level.
- Make sure the machine is properly calibrated.
- Your alignment equipment should be regularly calibrated in order to give correct information.
- Check with the manufacturer of your specific equipment for their recommended Service/Calibration Schedule.
Preliminary Check
Check the following:
1.Tires for improper air pressure and wear.
2.Road wheels for runout. Specifications.
3.Wheel bearing axial end play. Wheel Bearing.
4.Transverse link ball joint axial end play. Front Suspension.
5.Shock absorber operation.
6.Each mounting part of axle and suspension for looseness and deformation.
7.Each of suspension member, shock absorber, upper link and transverse link for cracks, deformation and other damage.
8.Vehicle height (posture).
Alignment Process
IMPORTANT:
Use only the alignment specifications listed in this Service Manual.
- When displaying the alignment settings, many alignment machines use "indicators" Do not use these indicators.: (Green/red, plus or minus, Go/No Go).
- The alignment specifications programmed into your machine that operate these indicators may not be correct.
- This may result in an ERROR.
- Most camera-type alignment machines are equipped with both "Rolling Compensation" method and optional
"Jacking Compensation" method to "compensate" the alignment targets or head units. "Rolling Compensation" is the preferred method.
- If using the "Rolling Compensation" method, after installing the alignment targets or head units, push or pull on the rear wheel to move the vehicle. Do not push or pull the vehicle body.
- If using the "Jacking Compensation" method, after installing the alignment targets or head units, raise the vehicle and rotate the wheels 1/2 turn both ways.
NOTE:
Do not use the "Rolling Compensation" method if you are using sensor-type alignment equipment.
- Follow all instructions for the alignment machine you're using for more information.

ADJUSTMENT

Camber, Caster and Kingpin Inclination Angles

CAUTION:
FSU
Camber, caster, kingpin inclination angles cannot be adjusted.