Front Wiper Auto Stop Signal Circuit

FRONT WIPER AUTO STOP SIGNAL CIRCUIT

Component Function Check


1. CHECK FRONT WIPER (AUTO STOP) OPERATION

CONSULT DATA MONITOR
1.Select "WIP AUTO STOP" of IPDM E/R DATA MONITOR item.
2.Operate the front wiper.
3.With the front wiper operation, check the monitor status.





Is the status of item normal?
YES- Auto stop signal circuit is normal.
NO- Refer to "Diagnosis Procedure".


Diagnosis Procedure

Regarding Wiring Diagram information, Front Wiper And Washer System Coupe or Front Wiper And Washer System Sedan.

1. CHECK IPDM E/R OUTPUT VOLTAGE






1.Turn the ignition switch OFF.
2.Disconnect front wiper motor.
3.Turn the ignition switch ON.
4.Check voltage between front wiper motor connector and ground.





Is the measurement normal?
YES- Replace front wiper motor. Service and Repair.
NO- GO TO 2

2. CHECK FRONT WIPER MOTOR (AUTO STOP) CIRCUIT CONTINUITY

1.Turn the ignition switch OFF.
2.Disconnect IPDM E/R connector E18.
3.Check continuity between IPDM E/R harness connector and front wiper motor harness connector.





4.Check continuity between IPDM E/R harness connector and ground.





Is the inspection result normal?
YES- Replace IPDM E/R. Service and Repair.
NO- Repair or replace harness.