B2850

Description

The on-board charger contains 3 temperature sensors, and monitors the temperatures of the charging circuit and control circuit board.
The on-board charger also compares the signals from each sensor and detects malfunctions of sensor characteristic.


DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT
1.Perform normal charging at least 10 seconds.
2.Turn power switch ON.
3.Check "SELF-DIAG RESULTS" of "CHARGER".
Is DTC detected?
YES- Proceed to "Diagnosis Procedure" .
NO- INSPECTION END

1. PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT
1.Perform normal charging at least 2 minutes.
2.Turn power switch ON.
3.Check "SELF-DIAG RESULTS" of "CHARGER".
Is DTC detected?
YES- Proceed to "Diagnosis Procedure" .
NO- INSPECTION END


Diagnosis Procedure


1. PERFORM CONFIRMATION PROCEDURE AGAIN

With CONSULT
1.Turn power switch ON.
2.Erase self-diagnostic result.
3.Turn power switch OFF.
4.Perform DTC confirmation procedure. Refer to "DTC Logic" .
Is the DTC detected again?
YES- Replace on-board charger. Refer to "Removal and Installation" Removal And Installation.
NO- INSPECTION END