C10E7

DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PRECONDITIONING

If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn power switch OFF and wait at least 10 seconds before conducting the next test.
- GO TO 2.

2. CHECK DTC DETECTION

With CONSULT
1.Turn the power switch OFF to ON.
2.Press the parking brake switch.

CAUTION:
- Put the select lever in the P position.
- Depress the brake pedal.
3.Pull the parking brake switch.
4.Perform self-diagnosis for "EHS/PKB".
Is DTC "C10E7" detected?
YES- Proceed to "Diagnosis Procedure" .
NO- INSPECTION END


Diagnosis Procedure


1. PERFORM SELF-DIAGNOSIS (1)

With CONSULT
1.Erase self-diagnosis result for "EHS/PKB".
2.Conduct parking brake switch operation (pull and push) after leaving approximately 1 minute.
3.Perform self-diagnosis for "EHS/PKB".
Is DTC "C10E7" detected?
YES-Check when parking brake actuator and parking brake rear cable are stuck.
- Parking brake actuator: Refer to "Inspection" Inspection.
- Parking brake rear cable: Refer to "Inspection" Inspection.
NO- GO TO 2.

2. PERFORM SELF-DIAGNOSIS (2)

With CONSULT
1.Repeat the parking brake switch operation (pull and push) 5 times.
2.Perform self-diagnosis for "EHS/PKB".
Is DTC "C10E7" detected?
YES- Replace parking brake actuator. Refer to "Removal and Installation" Removal And Installation.
NO- INSPECTION END