P1610

P1610 LOCK MODE

Description

VCM forcibly switches to the mode that inhibits vehicle to be READY, when READY set operation is performed
5 times or more while communication between VCM and BCM is not normal.


DTC Logic


DTC DETECTION LOGIC

NOTE:
If DTC P1610 is displayed with other DTC (for BCM or EV/HEV), first perform the trouble diagnosis for other
DTC.






DTC CONFIRMATION PROCEDURE


1. PERFORM DTC CONFIRMATION PROCEDURE

1.Turn power switch ON.
2.Check DTC in "Self Diagnostic Result" mode of "EV/HEV" using CONSULT.
Is DTC detected?
YES- Go to "Diagnosis Procedure" .
NO- INSPECTION END


Diagnosis Procedure


1. CHECK VEHICLE READY SET FUNCTION

1.Check that DTC except DTC P1610 is not detected.
If detected, erase the DTC after fixing.
2.Turn power switch OFF.
3.Contact the registered Intelligent Key backside to power switch and wait 5 seconds.
4.Turn power switch ON.
5.Turn power switch OFF and wait 5 seconds.
6.Repeat steps 3 and 5 twice (a total of 3 times).
7.Check that vehicle can be set to READY.
- INSPECTION END