P3101

DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PRECONDITIONING

- Turn power switch OFF and wait at least 20 seconds.
- Make sure that 12V battery voltage is 11 V or more.
- GO TO 2.

2. PERFORM DTC CONFIRMATION PROCEDURE

1.Turn power switch ON wait at least 10 seconds.
2.Set the vehicle to READY.
3.Shift selector lever to the entire position from "P" to "D".
4.Turn power switch OFF and wait at least 20 seconds.
5.Turn power switch ON wait at least 10 seconds.
6.Turn power switch OFF and wait at least 20 seconds.
7.Turn power switch ON.
8.Check self-diagnostic result.
Is DTC detected?
YES- Proceed to "Diagnosis Procedure" .
NO- INSPECTION END


Diagnosis Procedure


1. PERFORM CONFIRMATION PROCEDURE AGAIN

1.Erase DTC.
2.Perform DTC confirmation procedure again. Refer to "DTC Logic" .
3.Check self-diagnostic result.
Is the DTC detected again?
YES- Replace VCM. Refer to "Removal and Installation" Removal And Installation.
NO- INSPECTION END