P312D

DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PRECONDITIONING

- Turn power switch OFF and wait at least 20 seconds.
- Make sure that 12V battery voltage is 11 V or more.
- GO TO 2.

2. PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT
1.Check that the charging status indicator is not illuminating, and wait at least 20 seconds.
2.Connect quick charge connector.
3.Start the quick charging and wait at least 2 minutes.
4.Turn power switch ON.
5.Check DTC.
Is DTC detected?
YES- Proceed to "Diagnosis Procedure" .
NO- INSPECTION END


Diagnosis Procedure


1. PERFORM SELF-DIAGNOSIS OF ON-BOARD CHARGER

With CONSULT
Perform self-diagnosis of on-board charger.
Is DTC detected?
YES- Check the DTC.
NO- GO TO 2.

2. PERFORM DTC CONFIRMATION PROCEDURE AGAIN

With CONSULT
1.Erase DTC.
2.Perform DTC confirmation procedure again. Refer to "DTC Logic" .
Is DTC detected?
YES- Replace VCM. Refer to "Removal and Installation" Removal And Installation.
NO- Check intermittent incident. Refer to "Intermittent Incident" Intermittent Incident.