P3160

DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PRECONDITIONING

- Turn power switch OFF and wait at least 20 seconds.
- Make sure that 12V battery voltage is 11 V or more.
- GO TO 2.

2. PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT
1.Turn power switch OFF and wait at least 60 seconds.
2.Turn power switch ON and wait at least 10 seconds.
3.Check DTC.
Is DTC detected?
YES- Proceed to "Diagnosis Procedure" .
NO- INSPECTION END


Diagnosis Procedure


1. PERFORM SELF-DIAGNOSIS OF ELECTRICALLY-DRIVEN INTELLIGENT BRAKE UNIT

With CONSULT
Check self-diagnostic result in "BRAKE".
Is DTC detected?
YES- Perform diagnosis procedure of detected DTC.
NO- GO TO 2.

2. PERFORM DTC CONFIRMATION PROCEDURE AGAIN

1.Erase all DTC.
2.Perform DTC confirmation procedure again. Refer to "DTC Logic" .
Is the DTC detected again?
YES- Replace VCM. Refer to "Removal and Installation" Removal And Installation.
NO- INSPECTION END