P3175

DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PRECONDITIONING

- Turn power switch OFF and wait at least 20 seconds.
- Make sure that 12V battery voltage is 11 V or more.
- GO TO 2.

2. PERFORM DTC CONFIRMATION PROCEDURE

1.Turn power switch ON and wait at least 5 seconds.
2.Check DTC.
Is DTC detected?
YES- Proceed to "Diagnosis Procedure" .
NO- INSPECTION END


Diagnosis Procedure


1. REPLACE VCM

1.Replace the VCM. Refer to "Removal and Installation" Removal And Installation.
2.Turn power switch ON.
3.Erase DTC.
4.Perform confirmation procedure. Refer to "DTC Logic" .
Is DTC detected?
YES- Replace the electric shift control module. Refer to "Removal and Installation" Removal And Installation.
NO- INSPECTION END