P3183

DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PRECONDITIONING

- Turn power switch OFF and wait at least 20 seconds.
- Make sure that 12V battery voltage is 11 V or more.
- GO TO 2.

2. PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT
1.Turn power switch ON and wait at least 5 seconds.
2.Check DTC.
Is DTC detected?
YES- Proceed to "Diagnosis Procedure" .
NO- INSPECTION END


Diagnosis Procedure


1. REPLACE LBC

1.Replace LBC. Refer to "Exploded view" Service and Repair (without Li-ion battery heater), "Exploded view" Service and Repair (with Li-ion battery heater).
2.Turn power switch ON and erase DTC.
3.Perform DTC confirmation procedure. Refer to "DTC Logic" .
Is DTC "P3183" detected again?
YES- Replace VCM. Refer to "Removal and Installation" Removal And Installation.
NO- INSPECTION END