P318B

DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PRECONDITIONING

- Turn power switch OFF and wait at least 20 seconds.
- Make sure that 12V battery voltage is 11 V or more.
- GO TO 2.

2. PERFORM DTC CONFIRMATION PROCEDURE-I

With CONSULT
1.Turn power switch ON and wait at least 5 seconds.
2.Check DTC.
Is DTC detected?
YES- Proceed to "Diagnosis Procedure" .
NO- GO TO 3.

3. PERFORM DTC CONFIRMATION PROCEDURE-II

With CONSULT
1.Shift the selector lever to the entire position from P to D, and shift it to P position.
NOTE:
Hold the lever at each position for 15 seconds or more.
2.Check DTC.
Is DTC detected?
YES- Proceed to "Diagnosis Procedure" .
NO- GO TO 4.

4. PERFORM DTC CONFIRMATION PROCEDURE-III

With CONSULT
1.Set the vehicle to READY.
2.Drive the vehicle at 15 km/h (10 MPH) with the selector lever in D range. From this condition, shift the selector lever in R range.

CAUTION:
Always drive vehicle at safe speed.
3.Stop the vehicle.
4.Check DTC.
Is DTC detected?
YES- Proceed to "Diagnosis Procedure" .
NO- GO TO 5.

5. PERFORM DTC CONFIRMATION PROCEDURE-IV

With CONSULT
1.Drive the vehicle at 15 km/h (10 MPH) with the selector lever in R range. From this condition, shift the selector lever in D range.

CAUTION:
Always drive vehicle at safe speed.
2.Stop the vehicle.
3.Check DTC.
Is DTC detected?
YES- Proceed to "Diagnosis Procedure" .
NO- INSPECTION END


Diagnosis Procedure


1. CHECK SELF-DIAGNOSTIC RESULT IN ELECTRIC SHIFT CONTROL MODULE

With CONSULT
Check self-diagnostic result in "SHIFT".
Are any DTC detected?
YES- Check the DTC.
NO- GO TO 2.

2. REPLACE ELECTRIC SHIFT CONTROL MODULE

1.Replace electric shift control module. Refer to "Removal and Installation" Removal And Installation.
2.Power switch ON and erase DTC.
3.Perform DTC confirmation procedure again. Refer to "DTC Logic" .
Is the DTC "P318B" detected again?
YES- Replace VCM. Refer to "Removal and Installation" Removal And Installation.
NO- INSPECTION END