P325C

DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PRECONDITIONING

If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always power switch OFF and wait at least 10 seconds before conducting the next test.
- GO TO 2.

2. CHECK DTC DETECTION

With CONSULT
1.Power switch OFF and wait for 10 seconds or more.
2.Power switch ON and wait for 10 seconds or more.
3.Check DTC.
Is "P325C" detected?
YES- Go to "Diagnosis Procedure" .
NO- INSPECTION END


Diagnosis Procedure


1. RECORDING THE TRACTION MOTOR RESOLVER OFSET THAT IS STAMPED ON THE TRACTION MO-

TOR
1.Power switch OFF.
2.Remove the under cover and record the traction motor resolver offset that is stamped on the traction motor.
NOTE:
For the traction motor stamp location, refer to "Description" Description.
- GO TO 2.

2. WRITING OF TRACTION MOTOR RESOLVER OFFSET

Write the traction motor resolver offset to the traction motor inverter. Refer to "Work Procedure" Work Procedure.
- GO TO 3.

3. READING AND CHECKING TRACTION MOTOR RESOLVER OFFSET

1.Power switch OFF and wait for 10 seconds or more.
2.Power switch ON.
3.Use CONSULT to read the traction motor offset that is written to the traction motor inverter.
4.Check whether or not the read value matches the value which is stamped on the traction motor.
Do the values match?
YES- INSPECTION END
NO- GO TO 1.